L298P Arduino Dual Motor Driver Shield Board

Overview:

The L298P Motor Driver Shield is a multi-featured, H Bridge motor shield based around the L298P driver chip and fits Arduino Uno or other Arduino with compatible I/O pins. The L298P can directly drive two DC motors with drive current of up to 2A.

Features:

• Drive 2 DC motors at 4.8-24V at up to 2A peak (2.5A peak) current.
• Built-in Schottky diodes to protect against motor back EMF.
• Drive 1 servo motor with a dedicated 5V regulated power.
• Built-in buzzer.
• Remote reset switch.
• Bluetooth connector (x2).
• Ultrasonic Range Finder Ping connector.
• RGB LED connector
• 6 Analog/digital pins brought out to 3-pin headers with 5V and Gnd available for each input for easy sensor hookup.
• Stacking female connectors for supporting another daughter card.
• Can optionally power attached Arduino off the shield.

Specification:

• Logical input voltage VD: 5V
• Drive input voltage: VIN 6.5 - 12V, PWR IN 4.8 - 24V
• Logical working current ss: ≤ 36mA
• Drive working current Io: ≤ 2A
• Maximum power dissipation: 25W (T= 75°C)
• Control signal input electric level:
• High: 2.3V≤ Vin ≤ 5V
• Low: -0.3 V ≤ Vin ≤ 15V
• Operating temperature: -25°C ~ +130°C

Package includes:

• L298P Motor Driver Shield