4WD Obstacle Avoidance Smart Robot Car Kit

R 700.00

The 4WD Obstacle Avoidance Smart Robot Car Kit comes with all components required to build the car for obstacle avoidance.

Power up the 4wd car with 3.7v 18650 2500mah lithium batteries for the ultimate speed and performance. Control your car using bluetooth (Android only) with the HC-05 Bluetooth Module

Note: Batteries, charger and bluetooth module sold separately.  

Quantity

Currently out of stock - on back-order

Overview:

The 4WD Smart Robot Car Chassis Kit comes with four motors and wheels and is compatible with the Arduino UNO R3.

There are mainly four modules:

• Infrared signal detection module
• Main control module
• Motor drive module
• Ultrasonic sensor module

The smart car adopts a welding-free installation design. The components are fixed by copper pillars and screws. The circuit connection between each module is connected by DuPont wire, which is simple and convenient

Features:

• DC 6V 4-wheel Robot Smart Car Chassis Kits car with Speed Encoder for Arduino
• Mechanical structure is simple and easy to install.
• The main control board : CH340 UNO R3 board.
• The motor drive module uses a typical L298N module to drive a DC motor.
• The infrared signal detection module uses four infrared light pairs to detect the black line and realize the tracking function.
• The ultrasonic sensor module : HC-SR04 module, through which the distance is measured, so as to realize the ultrasonic obstacle avoidance function.

Contents:

• 2 × Acrylic transparent 4-wheel trolley floor
• 1 × CH340 Uno R3 with USB development board(with a data cable)
• 1 × L298N motor drive module
• 1 × Ultrasonic sensor module
• 1 × Four-way tracking module
• 4 × 5V DC gear motor (with wheels)
• 1 × Ultrasonic bracket
• 8 × Motor fixing bracket (acrylic transparent)
• 4 × Speed Code Disc (Black)
• 1 × 18650 battery box with switch
• 3 × M3*50 copper pillar
• 8 × M3*30 copper pillar
• 2 × M3*15+6 copper pillar
• 17 × M3 nuts
• 33 × M3*8 round head screw
• 8 × M3*30 round head screws
• 3 × M2 nut
• 2 × M2*8 round head screws
• 4 × M1.6*8 round head screws
• 4 × M1.6 nut
• 1 × Male to female Dupont wire 30cm
• 15 × Male to female Dupont line 20CM
• 8 × Male to male Dupont line 20cm
• 4 × Male to female Dupont wire 10cm
• 2 × Male to male Dupont line 10cm

Specifications:

• Power supply: 2 removable 3.7v lithium batteries
• Input: infrared sensor (four-channel), ultrasonic module (HC-SR04)
• Motor: DC geared motor
• Motor drive: L298N module
• Microprocessor: UNO R3 controller

Resources:

https://learn.arduinosa.co.za/arduino-robot-car/4wd-obstacle-avoidance-car

https://learn.arduinosa.co.za/arduino-robot-car/arduino-bluetooth-car

AD-Compl-4WD-Car

Specific References

You might also like